Measurement Forum Archive

Read-only historical archive of measure.infopop.cc

Changing a certified course from the 1st mile backwards

#1 • 10/3/25 @ 7:39 AM

I am having to change the first mile of a newly certified course only. I am planning on measuring backwards from the first mile. What paperwork do I have to submit? and what else, other than redrawing the first mile, do I need? Thanks for any help.

#2 • 10/3/25 @ 9:48 AM

It's best to ask your certifier. I assume you know who that is, but if not you can find him/her from the list at the link below.

https://www.rrtc.net/Certifiers/Certifiers.html

#3 • 10/5/25 @ 4:32 AM

Ask your certifier to confirm, but here’s how I’d handle it:

Unless your mile 1 split is already certified, you can’t assume it is. Measure the segment from the start to mile 1 along the original route twice, then measure the same segment along the new route twice. Use the shorter of each pair of measurements to find the difference and adjust accordingly.

The “Seg Alt Tool” tab in my measurement spreadsheet will calculate this for you. Be sure to enter all your calibration ride data in the sheet for the formulas to work properly. The "About" tab provides instructions on how to use the document.

Once you’ve completed your calculations, submit everything to your certifier as an LDS submission (export the relevant data from the spreadsheet - Info tab, Cal tab, Seg Alt Tool tab - into PDF files and email to your certifier).

#4 • 10/5/25 @ 7:12 AM

When doing an adjustment you must use the longer of your two measurements of the original course segment, and the shorter of your two measurements for the new course segment.

#5 • 10/6/25 @ 4:58 PM

Thank you for the feedback. I don't recall seeing that in the procedures manual, but it makes sense. Is that documented anywhere?

I've updated my spreadsheet accordingly.

#6 • 10/6/25 @ 7:11 PM

I just checked the Procedures Manual and it is not stated that you need to do it that way. But I have always been told to do it that way since it is the conservative approach.