Measurement Forum Archive

Read-only historical archive of measure.infopop.cc

Cal Course Address

#1 • 7/21/16 @ 10:02 AM
I needed a cal course yesterday for a measurement in a town far from where I live. Fortunately, generous Bob Thurston has taped many cal courses in the greater D.C. region. I found one nearby the course to be measured. Problem was, it is in the Beltsville Agricultural Research Center in Maryland, a 6,600 - acres/10.3 square mile plot, and Bob's excellent map, like most cal course maps I have seen, had no address listed for or near this course. Because Bob had indicated cross streets close to either end of the course on his excellent map, I was able to find it without difficulty.

Yet - I noticed a building on one side of the course. I couldn't help thinking how much easier it would have been to find if Bob had listed this address.
#2 • 7/21/16 @ 2:40 PM
I also like to have GPS coordinates for one end or the other. Always qualify the coordinates with "Near N39.12345° W104.12345°" This way, no one should replace an endpoint based on the coordinate.

Addresses are so last-century!
#3 • 7/21/16 @ 3:45 PM
Call me crazy but I never use someone else's calibration course without checking it.
#4 • 7/24/16 @ 2:50 PM
David, I think it would be crazy to use the course without checking it. I calibrated at home last weekend (2 a.m.), then drove 3 hours to the courses I was to measure. Dave Poppers set a cal course there in 2004. Nails and paint are still there. I rode his course, and got the same clicks I had gotten at home. Did post-cal on his course.

It is nice to have airless tires, as there is much less fluctuation due to elevation, and even temp.
#5 • 7/25/16 @ 1:23 AM
Just to clarify: David is saying he needs to check by steel tape, and Duane's check is a ride to see if the counts jibe with an already trusted cal course-- is that what you're saying?
#6 • 7/25/16 @ 2:57 AM
Lyman - you are correct. There have only been a few times that I used someone's calibration course without measuring it myself. Each of those times I was with the original measurer or I actually witnessed the measurement without having my hands on the tape.
#7 • 7/25/16 @ 1:00 PM
I use Duane's method unless it is a cal course made by a Measurer that I know and trust. That would include all of those thus far on this thread.