Measurement Forum Archive

Read-only historical archive of measure.infopop.cc

Please keep timers in mind

#1 • 1/20/15 @ 8:49 PM
I time races and measure them.
This post is to formally request that measurers make sure, whenever possible, that the start and finish points of a certified course are free of manhole covers (or other such large metal objects) in the road or bike path.
The reason? The metal in the manhole covers usually interferes with the RFID antennae used by chip timing equipment.
Thank you!
#2 • 1/21/15 @ 7:22 AM
Also - 15 feet beyond the finish as well as 15 feet prior to the actual starting line (back up lines).
#3 • 2/4/15 @ 8:29 PM
What about right beside the road?

I am working on two courses right now that look like the start/finish line will be right beside a storm drain (this is one of our "triple storm drains" with 3 manhole covers, and the start line could be right beside the middle one. Should I find a reason to move that line forward or backward to keep clear of those manhole covers?
#4 • 2/4/15 @ 10:09 PM
Bob
Check with the timing company. It may not be a problem for some timing systems.
#5 • 2/17/15 @ 8:20 PM
I followed David's suggestion. The timing company says a manhole like that (beside the start/finish line, over a storm drain) is not going to be a problem.

Of course the storm drain could be a problem-- I always think I'm likely to drop something that will fall into the storm drain. For this I probably need to consult a shrink not a race timer.
#6 • 7/24/15 @ 12:17 PM
Good suggestion. We use MyLaps and don't have issues with any metal objects. However, I would suggest a S/F that is smooth. MyLaps mats don't have much forgiveness of uneven surfaces