Measurement Forum Archive

Read-only historical archive of measure.infopop.cc

New Certification Form Guidelines

#1 • 12/26/11 @ 8:43 PM
I hope Duane or Gene will post the new guidelines here in the appropriate format but I'll leave that to them. I think at least part of the recent e-mail discussion belongs in this section rather than in the conversation about elevation.
A point I'd like to raise here is the matter of deciding what jurisdiction to assign a race to, in cases where the course goes through more than one. In particular I have 2 courses, the Marine Corps Marathon and the Army Ten Miler: both start and finish in Virginia but most of the route is in the District of Columbia. They have always had DC certification. I understood from long-ago discussions that this was the right decision, so I am puzzled upon seeing that the jurisdiction should be the state where the FINISH is located.
Nobody answered when I raised this question before, I guess in all the excitement about decimal points, but I'm hoping someone can address this point.
#2 • 12/27/11 @ 4:54 AM
There are times where it would be best to use the state where the races started as opposed to the finish , but in the above cases the code should have been VAXXXXXRT. However, these races are so well known as Washington, DC events. Hence, I could see why you used the code DCXXXXXRT.

I really don't see a problem here. Just let it be for now and the future.
#3 • 12/27/11 @ 5:01 AM
I would tend to agree with Bob T. on this issue. The average runner searching for the Marine Corps Marathon or Army 10 map in the database would 9 times out of 10 use D.C. as the location.