Measurement Forum Archive

Read-only historical archive of measure.infopop.cc

Calibration Courses

#1 • 5/8/10 @ 8:12 AM
Hi all. I am relatively new to measuring courses compared to most here, but have been "unofficially measuring" small local races for a couple years where I live, using the USATF standards.

I have what might seem an obvious question to some, but would like to get input on it. I have used a 1000 meter course before, and the math on that was easy as it relates to the counts per kilometer when actually measuring the course.

What if you use a 300 meter course? If I do my calibrations and at the end of all of the procedures I come out with a working constant of say 2800 counts for 300 meters, how does that get turned into what the count should be for a kilometer. Is it simply 300 meters is 2800 counts, 100 meters is 933.333333 counts, and therefore 933.33333 x 10 = 9333.3333.

Therefore 9333.33333 counts = 1000 meters?

Again this might be obvious, but just want to make sure I'm going about this the right way.

Thanks in advance,
Chris
#2 • 5/8/10 @ 10:08 AM
Chris,

You've got it right except, for course layout, you should multiply the 9333.33333 by 1.001, the SCPF (short course prevention factor), and wind up with a constant of 9342.67 counts per kilometer.
#3 • 5/8/10 @ 6:38 PM
Thanks for the quick response Pete, and for doing this discussion board. Learned alot just from reading these threads.