Measurement Forum Archive

Read-only historical archive of measure.infopop.cc

use of edm in measuring

#1 • 1/4/08 @ 9:05 PM
A measurer in my area has a 10K to run at the Marine base in Quantico, VA. About 2 km of the course goes over a deeply rutted road that is too rough to ride a bike over, so he proposes to use EDM equipment (which he will rent) to measure that portion. That seems reasonable to me, and my question is, do we still add a SCPF for the portion that is measured electronically? I think the answer is yes, but I'm not sure and I don't know how the reasoning goes here-- any help?
Thanks,
Bob Thurston
#2 • 1/5/08 @ 3:01 AM
This has been argued endlessly in the past, with people citing the need for different SCPF's for different measuring methods. I believe the final consensus was to use the 1.001 SCPF regardless of the method used to lay out the course.

Remember, the SCPF also covers minor race-day setup errors.
#3 • 1/6/08 @ 8:14 PM
Thanks, Pete. I think that's the way I remember it also. In addition there is the question of interpretation-- someone could easily do an extremely precise measurement of a line other than the SPR, etc.