Measurers often seem to calculate the % difference between two counts by first converting them to the equivalents in standard units of length. (Farcically I have seen some of these lengths expressed down to one thousandth of a mm!)
These conversions are unnecessary because the % dfference can be more easily calculated directly from the counts themselves. This is particularly easy on HP calculators with RPN where only the counts are entered and the % change button pressed:
C1, enter, C2, shift %chg
% DIFFERENCE CALCULATION
I often measure with another rider where the counts from one bike differ in length to the other's. Conversion to standard units is the simplest way for me to understand how the two riders' measurements relate to one another.
Laurent:
Counts from one rider can be compared with those from another through the ratio of their calibration constants.
Counts from one rider can be compared with those from another through the ratio of their calibration constants.