Measurement Forum Archive

Read-only historical archive of measure.infopop.cc

Concrete curb

#1 • 10/10/05 @ 5:21 PM
I am measuring a course with a concrete curb which extends 17 or 18 inches past the vertical surface. It is at a slightly steeper slope than the asphalt street it meets. Due to a combination of roughness and slope, about half of it has sticks and leaves in it at any given time. I wouldn't any of it with the exception of a 90 degree corner because of the slope and foreign objects but it is still pavement. How do I handle this?
#2 • 10/11/05 @ 3:06 AM
This is a judgment call. Generally if a gutter is too rough to ride in I think of it as an imaginary curb, and ride on the asphalt close to the joint. When I get to the corner, though, I cut in and ride nice and tight. It's on the corners where errors will make the big difference.
#3 • 10/11/05 @ 6:54 AM
Maybe you could also consider doing an offset maneuver as you would with any temporary obstruction on a course during measurement. Obviously you can't do this on a 90 degree curve because as Pete pointed out, it would result in a pretty big error. However, it should be applicable on the straight(er) sections.
#4 • 12/9/05 @ 6:16 PM
Oscar's question reminds me of a time when I measured a 5K course during the height of leaf-raking season, and there were huge piles of leaves in the way of a good measurement, including some of them right at the corners. I dealt with this in 2 ways-- sometimes I projected a point from the curb out into the street and then "copied" the curve at the corner (still out in the street) until I got around the (virtual)corner to a point corresponding to an accessible point of the real curb. (Oh well, it's easier to do than to describe).
Another, simpler way, is sometimes possible: just put your bike up onto the curb and measure along the top of the curb. You won't shortchange the course. I think the course I'm remembering didn't have curbs where that was possible; they were those sloping curbs that don't have a "top".